The cutting blades of the cutting machine are very simple

Prepare tools, flexible wrenches, and new cutting blades in advance when replacing the cutting blades. The specific operational steps are

The first step is to cut off the power supply to ensure safety.

The second step is to find the shaft locking device. First, locate the cutting blade transport shaft. One end of this shaft is the cutting blade, and the other end is the belt

The wheel has a bearing box in the middle, and there is a protruding cylinder in the middle of the bearing box, which is the shaft locking device.

The third step is to fix the cutting blade's rotating shaft. While holding down the shaft locking device, rotate the cutting blade's rotating shaft,

While rotating the shaft, swing the shaft significantly left and right. When the shaft locking device locks the small hole on the shaft, the shaft is fixed.

The fourth step is to use a flexible wrench to remove the fastening bolts of the cutting piece while holding down the shaft locking device. Take them one by one

Lower the cutting blade to protect the disc, paper pad, and old cutting blade. Then you can put the new cutting piece in, and install the paper pad and protective disc in sequence.

The final step is to use a flexible wrench to tighten the bolts. library

www.hslichuang.com